Honda outboard service/repair manual – Seloc | 4-stroke | 4 stroke | Table of Contents PDF file | 2 hp – hp – 4 hp – 8 hp – 40 hp – 50 hp – 75 . Clymer Honda Outboard Marine service and repair manuals are written with model specific coverage for your Honda Outboard Marine. From basic service and. View and Download Honda Outboard Motor BFA owner’s manual online. Honda Power Equipment Outboard Motor Owner’s Manual. Outboard Motor.

Author: Mokazahn Vogul
Country: Angola
Language: English (Spanish)
Genre: Marketing
Published (Last): 17 June 2010
Pages: 356
PDF File Size: 3.81 Mb
ePub File Size: 3.62 Mb
ISBN: 861-9-33402-458-8
Downloads: 62059
Price: Free* [*Free Regsitration Required]
Uploader: Meztirg

It is intended to be used by a skilled technician. Shop Manual This manual covers complete maintenance and overhaul procedures.

Thoroughly outboxrd the water separator cup. To move the lever out of the N neutral position, you must squeeze the neutral release lever on the underside of the lever handle.

Owner’s Manuals

If oil pressure becomes low, the indicator will hnoda off, and the engine protection system will limit engine speed. If a fuse is blown, install a replacement fuse of the same specified rating.

Take outboard motor to an authorized Honda marine dealer, or refer to the shop manual. When the boat is to be moored for a long time, tilt the outboard motor as far as it will go.

The engine exhaust from this product contains outbooard known to the State of California to cause cancer, birth defects, or other reproductive harm. These gasolines are collectively referred to as oxygenated fuels. Misfiring or backfiring under load.


Honda Marine | Owners’ Manuals

The engine will not start if the F forward or R reverse gears are engaged. Adjust the trim tab in small increments, and retest steering effort with the boat evenly loaded and running at cruising speed.

Handle fuel only outdoors. Comments to this Manuals Your Name. Use starting procedure p. Page of Go. When used as described, the emergency stop switch and lanyard system stops the engine if the operator falls away from the controls. Honda power equipment outboard motor owner’s manual 49 pages.

Propeller Replacement Before replacing the propeller, remove the clip from the engine stop switch to prevent any possibility of the engine being started while you are working with the propeller.

Normal Engine Stopping To stop the engine in an emergency, pull the clip out of the emergency stop switch by pulling the lanyard. Reassemble the water separator body and the cup. Remove the three screws and separate the fuel strainer cup from the strainer body. The 10A main fuse protects the ignition switch and related circuits.

Run the engine at trolling speed. Honda power equipment outboard motor owner’s manual 45 pages.

Possible Cause Fast idle lever raised side-mount type. The tachometer shows engine speed in revolutions per minute. Gasoline is highly flammable and explosive.

Page 69 Remove the two mud guard clips from the upper part of the under cover grommet. Page 88 Check fuel. Check the water separator for water contamination. Do not try to remove the mud guard clip with f orce without raising the mamual part of the mud guard clip.


Fuel filter or fuel tank clogged. When the boat is not in use, remove and store the ignition switch key and the emergency stop switch clip and lanyard.

And using this outboard motor safely is an important responsibility. This shows that water is circulating through the cooling system. Set the end of outbord hose toward the outside of the engine undercase.

Honda Outboard Motor BF135A Owner’s Manual

Starting The Honea The emergency stop switch clip and lanyard system is a safety device that will stop the engine if you fall away from the controls while operating the boat. Clean it or consult with an authorized Honda outboard motor dealer for cleaning. LAUNCHING To raise the outboard motor out of the water while the engine is stopped and the boat is moored, or for maximum clearance when beaching or launching, use the power tilt switch on the engine pan to tilt the Panel-mount Type The emergency stop switch clip and lanyard system is a safety device that will stop the engine if you fall away from the controls while operating the boat.