ASTM A Standard Specification for Steel Strip, High Carbon, Cold Rolled, General Requirements. Find the most up-to-date version of ASTM A at Engineering ASTM A, AM – Designation: A /A M – 02 An American National Standard Standard Spe.
|Published (Last):||3 October 2017|
|PDF File Size:||2.29 Mb|
|ePub File Size:||9.63 Mb|
|Price:||Free* [*Free Regsitration Required]|
This edge is produced when the width tolerance and edge condition are not as exacting as for No. Limits on such elements are by agreement between purchaser and supplier. Z682 values from the two systems will result in nonconformance with the specification.
Number of Tests and Retests The elements comprising the desired chemical composition are speci?
A number in parentheses indicates the year of last reapproval. Strip is classified as product that is 0. Two additional samples are secured from each end of the coil from which the original sample was sstm. C When the chromium is speci? NOTE 2—The industry de? Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM A Steel, Strip, High Carbon, Cold Rolled, General Requirements
The strip may be subjected to product analysis xstm the purchaser either for the purpose of verifying that the chemical composition is within speci? Link to Active This link will always route to the current Active version of the standard.
Conformance to SI tolerances is mandatory when the “M” specification is used. Note 1—The term weight is used when inch-pound units are the standard. Unless otherwise agreed to, all tests and inspections, except product analysis, shall be made at the place of production. aztm
Dimensions, Mass, and Permissible Variations 9. It is normally produced as a fully killed steel.
Over 12 Through 11? The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other.
For strip length under mm, camber tolerance shall be subject to negotiation. B The sum of copper, nickel, chromium, and molybdenum shall not exceed 0. C Number 3 edge strip with thickness tolerance guaranteed a68 less than 3?
Last previous edition A — Within the text, the SI units are shown in brackets. Stay on Page Continue to Compass. Notwithstanding the absence of a signature, the organization submitting the EDI transmission is responsible for the context of the report. Table 3 shows requirements for additional elements. A portion of the coil may be discarded prior to cutting the samples for retest.
The ability of manufacturers to meet asrm maximum coil weights depends upon individual mill equipment. However, the document shall clearly identify the organization submitting the document.
ASTM A682 Grade 1074
ASTM International takes no position respecting the aa682 of any patent rights asserted in connection with any item mentioned in this standard. NOTE 1—The term weight is used when inch-pound units are the standard. Combining values from the two systems will result in nonconformance with the specification. Note 1—The term weight is used when inch-pound units are the standard.
General Requirements for Delivery 4. The values stated in each system are not exact equivalents; therefore, each system must be ashm independently of the other.